JustВ pull up on the lever, and pop in a new blade вЂ“ itвЂ™s pretty simple.В The trick is that currently the only accessories that are compatibleВ with the Porter-Cable are their own. With the Porter-Cable tool,В there is no excuse now, to not use the right blade for the job. What we have seen in the past is that manyВ times guys will just pick one blade and use it for cuttingВ everything, even if it was not meant for the task, because it is aВ little bit of a hassle to change them. Sure the Fein blade changeВ system was good, but we think the Porter-Cable is better after weВ spent some time with it. Since the advent ofВ the multi-tool market by Fein some years ago, no one else has come upВ with a true tool-free blade change system. Porter-Cable wins the innovation award for sureВ with their new PC250MTK Oscillating Multi-Tool. Given how manyВ there are now, if you want your tool to stand out you need to beВ pretty innovative. HavingВ spent time with nearly every oscillating multi-tool on the market hasВ made it easy to spot when something is different. Porter-CableВ PC250MTK 2.5A Oscillating Multi-Tool Kit Porter-Cable PC250MTK Multi-Tool TestingВ and Use High-SpeedВ Steel Flexible Scraper Blade.4вЂіВ Half Round High-Speed Steel Flush Cut Blade.1-1/2вЂіВ by 1-5/8вЂі Bi-Metal Wood and Metal Plunge Cut Blade.

1-1/2вЂіВ by 1-5/8вЂі High-Speed Steel Wood Plunge Cut blade.1-1/2вЂіВ by 1-5/8вЂі High-Speed Steel Precision Plunge Cut Blade.HereВ is a quick run-down of the accessories that come with the tool kit: The best thing with this tool-freeВ system is that there are no removable parts, which is good for meВ because I tend to lose small things. The blades canВ be adjusted and locked into 30 degree increments depending on howВ they are inserted into the collet. The accessories eachВ have nine holes that line up with the taped pins inside the collet.В The pins in the collet are tapered so that, as both the tool and theВ accessories wear, they will always retain a tight fit and maximizeВ the amount of torque the motor transfers to the blade. Simply giveВ the spring-loaded metal arm on the bottom of the tool a squeeze andВ you can pull out the accessory from the collet. Now, where this oscillating tool is differentВ than all the rest is the tool-free blade change system. TheВ on/off switch is a sliding type that is located near the front top ofВ the tool which puts it in easy reach for when you are holding theВ tool around the middle. The variableВ speed control allows for anywhere from 10,000 to 20,000 oscillationsВ per minute (OPM) and provides 2.8 (total) degrees of oscillation. TheВ PC250MTK comes with a 2.5 amp, high-torque, variable-speed motor thatВ is controlled by a dial towards the back of the tool. The long cord means that you will probably be able toВ work on most things without having to use an extension cord. When we initially pulledВ out the tool we were shocked to find a 10 foot long cord tucked inВ the tool case. TheВ overall body of the tool is made of gray glass filled nylon with about 75% ofВ the outside covered with rubber overmold. TheВ Porter-Cable PC250MTK Oscillating Multi-Tool Kit come all packaged upВ inside a sturdy black plastic tool case that has room to store theВ tool along with a decent collection of included accessories. Porter-Cable PC250MTK Oscillating Multi-Tool Features

Multi tool porter cable